Spare parts Translogic
TLS-TR-FF-70
Translogic Tie-rod for installing the DCS sensor.
M6 female-female thread / left-handed thread - right-handed thread / length 70mm (can be shortened to 30mm).
CHF25.00
TLS-DCS-M6-5VJ3
TRANSLOGIC - "Durashift" DCS Sensor JST-5V-M6
Recommended retail price
CHF259.00
Tax Included
- DCS "Durashift" single sensor 5 volt, with M6 male & female threads.
- This model equips the majority of "Translogic" Kits.
- Works in both directions "Push & Pull".
- Supplied with 3 pin JST connector.
checked In stock
DCS M6 sensor (spare part)
This sensor with M6 male threads on one side and M6 female on the other, works with a voltage of 5 volts. It includes 1 3-pin JST connector.
"Durashift" type DCS sensor
Tested on over 1 million gear changes, Translogic's "Durashift" DCS sensors are ultra-durable, made from special stainless steel alloys. Specially designed for endurance, it is the No. 1 choice of manufacturers for reliability and performance. "Durashift" DCS sensors are dual-channel and can operate in both "Push & Pull" directions, depending on the "Standard or Reverse" gear change configuration. They are also available in 3-wire 5V configurations to be compatible with the shifter systems of the original ECU.
TLS-DCS-M6-5VJ3
Data sheet
- Sensor
- DURASHIFT DCS Dual Channel
- Materials
- Stainless steel alloys
- Connectors
- 1x 3 pin JST
Specific References
16 other products in the same category:
- DCS "Durashift" single sensor 5 volt, with M6 male & female threads.
- This model equips the majority of "Translogic" Kits.
- Works in both directions "Push & Pull".
- Supplied with 3 pin JST connector.